ZAMP Z20 shields for RZ series
colour:
Klar
€45.00*
Content:
1 Stk
Available
Available immediately (%pieces% pieces)
Delivery as soon as available, ready for dispatch in 10 days (%pieces% pieces)
Articel number:
15426_V.137
EAN:
873895026536
Manufacturer:
Zamp
Manufacturer number:
HASZF20CL
Product information "ZAMP Z20 shields for RZ series "
The Zamp Z-20 series shields are designed to fit all Zamp RZ Series helmets.
The Zamp Z-20 shields are 3mm thick with tear-off posts.
All Z-20 Visors also come with an anti-fog coating. Zamp Z-20 Shield
Replacement: NOTE: It is important to NOT USE power tools or over tighten screws when changing shields.
Step 1 Lay a towel on a flat surface and set the helmet on it.
Step 2 Remove the shield pivot tensioners on each side. This is the smaller screw on the sides of the shield.
Step 3 Remove shield pivot screws on each side. This is the larger screw on the side of the shield. For best results, we suggest using a quarter to loosen/tighten this.
Step 4 Remove shield. We suggest using a cloth towel to wipe down the rubber seal as well as where the shield mounts to the helmet for best results.
Step 5 Place shield on helmet. There are two white washers that go between shield and helmet, make sure they are in place before re-installing shield.
Step 6 Hand thread in the shield pivots (larger screw) to hold the shield in place. Once hand threaded, use a coin and tighten until they are snug with helmet shell. Do not over tighten.
Step 7 Hand thread in the shield pivot tensioners, then tighten to desired tension for shield movement.
The Zamp Z-20 shields are 3mm thick with tear-off posts.
All Z-20 Visors also come with an anti-fog coating. Zamp Z-20 Shield
Replacement: NOTE: It is important to NOT USE power tools or over tighten screws when changing shields.
Step 1 Lay a towel on a flat surface and set the helmet on it.
Step 2 Remove the shield pivot tensioners on each side. This is the smaller screw on the sides of the shield.
Step 3 Remove shield pivot screws on each side. This is the larger screw on the side of the shield. For best results, we suggest using a quarter to loosen/tighten this.
Step 4 Remove shield. We suggest using a cloth towel to wipe down the rubber seal as well as where the shield mounts to the helmet for best results.
Step 5 Place shield on helmet. There are two white washers that go between shield and helmet, make sure they are in place before re-installing shield.
Step 6 Hand thread in the shield pivots (larger screw) to hold the shield in place. Once hand threaded, use a coin and tighten until they are snug with helmet shell. Do not over tighten.
Step 7 Hand thread in the shield pivot tensioners, then tighten to desired tension for shield movement.
Downloads